Error code
GE dishwasher error code C7
GE dishwasher error code C7: The water temperature sensor circuit has become inoperative. Which machines can actually raise it, where the number lives on this make, and what to do next.
- From $95 diagnostic, credited to the repair
- 59 cities and neighborhoods covered
- OEM parts available on order
- In writing the price, before anything is opened
What we can confirm
Code C7, from the manufacturer's own documentation
A code is only meaningful together with the machine showing it — the same digits mean different things on different equipment.
The code
C7
The water temperature sensor circuit has become inoperative. Where C6 is about the water, this is about the appliance's ability to measure it — so no amount of running the faucet will change it.
or call (305) 306-2503
What it narrows down to
The water temperature sensor circuit has become inoperative.
Diagnostic
From $95, credited to the repair
On the same appliance
What else belongs to the dishwashers
On this make a code belongs to the appliance rather than to a product line. These are the other conditions this machine can display, and the models that can show this one — a display often has more than one thing to say, and the model number decides what any of it costs to put right.
Other codes this appliance can display
The pump out during drain has exceeded two
The total pump out cycle exceeds seven minutes.
The dishwasher will not drain. Where C1 and
The machine filled twice after a power failure,
The pump out time is too short —
The water temperature is too low. GE is
The detergent cup is blocked from opening fully.
Not an error. GE lists this as a
There has been a power failure to the
Failure to drain — GE lists it as
A possible leak has been detected, and on
Not an error. GE describes a number followed
The same digits mean different things on different equipment. Search the full code list
In more detail
About GE dishwasher error code C7
What C7 means, in the maker's own words
The water temperature sensor circuit has become inoperative. Where C6 is about the water, this is about the appliance's ability to measure it — so no amount of running the faucet will change it.
Where this code actually appears
On the control panel, and usually with a sound. GE describes their refrigerator codes as flashing green on the display and typically accompanied by a beeping, and the range, microwave and dishwasher tables all describe codes you can read from the front of the appliance. That is the opposite of some makes, where the number is written into a hidden log and never shown — here, if something is wrong, the appliance generally tells you. Photograph what it says before cutting the power, because a reset erases it and the code is most of the diagnosis.
What to do about it
- Disconnect the power at the circuit breaker for about 30 seconds and reset the dishwasher.
- If the code returns, it is a service call: the sensing circuit is measured rather than reset repeatedly.
- Worth noting: a machine that cannot read its water temperature will also wash badly, so this often arrives as two complaints.
Where this goes next
The job this usually becomes is dishwasher wash performance service, and every one of those pages carries a starting figure and the reasons that move it. If it turns out to be nothing — and on this make a real share of these are modes rather than problems — the visit ends there and you pay the diagnostic and nothing else, or call (305) 306-2503 and describe what the display is doing before booking anything.
This article is based on:
- Official manufacturer documentation
- Internal repair procedures
- Technician repair history
- Company quality standards